Activity

Reply by SBS_Architect

I suggest you demo part of the existing walk where you are going to tie-in. Create a level landing at the intersection of the two...
SBS_Architect

Reply by Sean

RonU posted: You can warp new const to 2% at join to exist. At the join r/r width of new by width of existing and warp from 2% at join...

Reply by RonU

You can warp new const to 2% at join to exist. At the join r/r width of new by width of existing and warp from 2% at join to exist.

Reply by rlga_AZ

It was in the old UBC and did not make the transition to the IBC. The 2000 and 2003 editions of the IBC had other graphs there were used...
rlga_AZ

Reply by CB

Stu_SLO posted: This is what my Code says and it is not under a ramp section Thank you Stu_SLO!!! I was looking into the 2013 CBC and...

Reply by CB

Stu_SLO posted: Also see 1010.1.1 Exception 3 This is for ramps, not Janitor Closet.

Reply by CB

Stu_SLO posted: I have always looked at them as employee works area (CBC 11 B-206.2.8 or ADAAG 206.2.8.) Also do a search for Storage...

Reply by Stu_SLO

I have always looked at them as employee works area (CBC 11 B-206.2.8 or ADAAG 206.2.8.) Also do a search for Storage

Reply by rlga_AZ

1) Travel within an exit (i.e., enclosed exit stairway or ramp, exit passageway, exterior exit stair) is also not included in the travel...
rlga_AZ

Reply by hnQ

Thank you Mr. Geren. What a surprise I ran into you again. We exchanged emails a long while ago, >10 yrs, when I was a student (I am...

Reply by rlga_AZ

Since no one else has responded, I'll make an attempt at it. I have no clue what this drawing is trying to depict. The scale is all over...
rlga_AZ

New Member

Reply by BrentWiese

Thanks guys! Yep, nice and warm here, beautiful day outside my window right now. The stage is placed on one leg of an existing...
BrentWiese

Reply by Stu_SLO

Hey there Brent, hope all is well on the other side of the world. I am not following how the centerline shown is actually the centerline...
×
×
×
×
×